 |
 |
| Example of our indoor mechanical trim |
Example of our indoor mechanical trim |
 |
 |
| Example of our indoor mechanical trim |
We run all of our refrigerant tubing with clean bends and straps |
 |
 |
| Our outdoor refrigerant tubing is run with clean bends and is strapped to electrical wires inside sealtite protective tubing |
Our outdoor refrigerant tubing is run with clean bends and is strapped to electrical wires inside sealtite protective tubing |
 |
 |
| We use silicone caulking to seal our ductwork on trim (joints that don't have this caulking have been sealed on the inside) |
We can run exposed spiral pipe that as been treated to a copper finish |
 |
 |
| Example of our outdoor mechanical trim |
Example of our rooftop package unit trim |
 |
 |
| We use only radius fittings and we Kool-Koat all of our roof ductwork |
Example of our indoor mechanical trim |
 |
 |
| We coil our thermostat wire and paint our condensate drains white |
We coil our thermostat wire and paint our condensate drains white |
 |
 |
| Our ductwork drops are always leveled off and are straight and square |
Our ductwork is custom made for each house. It is mastic sealed and internally lined with R6 insulation. |
 |
 |
| Our ductwork is custom made for each house. It is mastic sealed and internally lined with R6 insulation. |
We run flexible duct smoothly without sags and kinks. Our register boxes are always squared off on 2 sides when we leave a job |
 |
 |
| All of our flexible duct is always supported as necessary with nylon strapping |
Flexible duct must be supported and run smoothly to prevent restriction on airflow |
 |
 |
| We wrap our register boxes with R6 foil faced insulation to prevent heat gain |
All of our flexible duct is always supported as necessary with nylon strapping |
 |
Our stat wire is strapped to prevent damage and there
is always excess coiled in the wall for future need |
